Subject:

Comments:
: : Hi Dave, : : I was reading you article on getting more out of the amps and my only question is: if I switch the amp to bridge mode do I still send a signal to channel B? I use it on stereo configuration righ now. I suppose I should, but its better to be safe than sorry. : : Thank you for all the usefull information you post for all of us. : : : : Alan Rosales : : PRO S L V : : OK, if you are using the amp in stereo mode and still require a stereo signal then you would not switch to bridge mode. You would just reverse pin 2 and 3 on the input to channel 2 and reverse the speaker leads on channel 2 as well. : If you do not require a stereo signal (IE you are sending the same signal to channel 1 and 2) then you would put the amp in bridge mode, only use the input to channel 1 and reverse the speaker leads to channel 2. : Hope that makes sense. Let me know if you need more info. : Dave Rat

Optional Link URL:
Link Title:
Optional Image URL:

Please use the new Rat Message board located at http://ratsound.com/cgi-bin/yabb/YaBB.cgi