Posted by Sergio on January 31, 2002 at 20:37:38:
Hi, my name is Sergio, how are you guys? I read your article on "fighting for power", and I have a couple of questions that I hope you could answer for me.
I'm running the low signal from my crossover to two qsc plx3402's(I'm using a 1ft xlr cable from input B of amp #1 to input A of amp #2 to make both amps run the same signal[lows]) For subs, I'm using four cabinets of the jbl sr-4719x(two 18" speakers per cabinet, which are rated at 1200 rms at 4ohms). I'm running two cabinets per amp, bridged. The way I have it hooked up is from amp to cabinet 1, then, from cabinet 1 to cabinet 2, I do a "daisy chain".
Now that you have an idea of how I have my system hooked up(I hope is the right way!), my question is this...Since I'm running my amp bridged, do I need to switch the positive end of my cable going to the speaker to the negative of the speaker, and then the negative of my cable to the positive of the speaker? Or do I only need to switch the ends on my amp? Or switch the ends of my amp and the ends of my speaker?
I'd really appreciate your help. Thank you.
Post a Followup